Inserting your Scleral Lenses

The following video may be helpful you in inserting your scleral lenses.




All of our patients are taught how to insert and remove their scleral lens. The average time needed to insert a scleral lens is a matter of seconds. Even less time is needed for removal of the lenses. The rubber appliances with the holes in the center are used for lens insertion. The appliance without the hole is used for removal of the GVR scleral lens. This last appliance is also shown at bottom.




SMAP 3D Scleral Lens Design

Last year we introduced an exciting piece of technology that has allowed us to custom design a scleral lens much more accurately. It is the SMAP 3D, which is a computer attached to a dedicated camera that allows us to obtain a 3 dimensional image of the entire front surface of the eye, including the cornea and the surrounding white portion of the eye (the sclera). Up until now there has not been any technology that would allow us to measure the ocular curvatures outside the cornea. The SMAP allows us to do this. Read More

Have Twitter?

Follow @Boshnick or check https://twitter.com/boshnick

Have Instagram?

Dr. Boshnick on Instagram

Check out EyeFreedom.com

EyeFreedom.com

The NEW YORK TIMES on LASIK

Blurred Vision, Burning Eyes: This Is a Lasik Success?

EyePrint Pro

EyePrintPro technology creates a scleral lens based on a mold of the cornea. The molding is accurate to 1 or 2 microns and fits perfectly because it exactly mirrors the irregularities of the individual corneal surface. The technology is well suited for post-Lasik, Keratoconus, RK, eye injury, and corneal transplant patients. Read More in this PDF about EyePrintPro Scleral Lens Technology

Watch Video at YouTube